Micron-SE is a computer setworks for accurate and fast positioning of the saw head of the machine to the required size for sawing. 
 
Micron-SE set can be installed on a horizontal or vertical band sawmill of almost any design. Micron-SE has a specially designed display and keypad for the convenience of the band sawmill operator - we have received a lot of positive feedback.
Sawmill electronic scheme modification is NOT required to install Micron-SE. So, any electrician can repair and service the machine.
 
Micron-SE has superior EMI protection. Micron-SE does not require additional programming, just “install, set, and run".
                                    
Functions:                                             
- Accurate and fast positioning of the saw for sawing
- The kerf thickness of the cut is always taken into account when positioning for sawing
- Top-down sawing mode board by board
- Compiling a list of boards when calculating from the bottom up to get the last board of the required size
- “Quick list” of boards based on how high the saw is located
- Two types of tips for the operator to compile the optimal list of boards
- Built-in special program for sawing log into lamellas
- Three possible modes of moving sawblade up over the cut (“bump up”)
 - 4 quick sizes and 4 quick lists
 - Display of the cutting motor load during cutting, warning to the operator about the possible overload of the main cutting motor (AC)
 - Ability to control both a single-speed motor and a two-speed motor
- 8 quick sizes and 12 quick lists
- Possibility to enter the thickness of the board with a decimal part (for example, 25.5mm)
- Built-in self-diagnosis features. For example, the Micron-SE controller always knows where the minimum and maximum values ​​are in height and will never go beyond these values ​​and even more. 
- Button for automatic positioning to the entered height. This feature allows the Micron-SE to be installed on edgers, resaws, etc.
- the “fastAction” positioning algorithm and automatic adaptation to the type of machine drive (no need to recalibrate 2 times a day)
- Visualization of the positioning process on the size
- Ability to connect two external buttons for more convenient operator work
- Operating temperature from -30 to 55 degrees C.